VAS. Vibration analysis boards

VAS-100 is a microcontroller-based analysis board for passive vibration/shock detectors. Although it has been specifically designed for CLIC V-series sensors, it offers full compatibility with any passive, normally closed vibration detectors on the market. It accepts multiple sensors connected in series to its input, up to a maximum of 10 units.

It offers two independent outputs, each driven by an electromechanical relay. The first output gets open for 2 seconds in case of alarm. The second one gets open in case a tamper condition is detected on the input, such as open circuit or magnetic tampering on CLIC V-series sensors.

The board can be configured with two different parameters: the threshold for strong shocks (1-20msec), and the number of weak shocks that triggers an alarm (1-8). Read more

VAS-400 and VAS-800 are analysis boards for passive vibration/shock detectors, with 4 independent channels (VAS-400 models) or 8 independent channels (VAS-800 models). Although they have been specifically designed for CLIC V-series sensors, they offer full compatibility with any passive, normally closed vibration detector on the market. Each port accepts a single sensor or a series of up to five sensors. Each detector can be installed with or without EOL resistors. In the latter case, the board automatically detects its value, from 2.2 kOhm to 11 kOhm.

Each channel has an independent alarm output port. One tamper output port is shared by all channels. Each alarm output gets open for 2 seconds when configuration thresholds are exceeded by the corresponding detector. The tamper output gets open for 2 seconds when one of the following conditions applies to one of the input detectors: open circuit, magnetic tampering on CLIC V-series sensors, short circuit, variation in EOL resistor value (only for detectors with EOL resistors). Tamper events are also signalled by the blinking of the output LED that corresponds to the input port that generated it, which simplifies maintenance operations.

The board analyses impulses from each detector according to four configuration parameters, which are set independently for each channel: the strong shock threshold (1-20msec), the weak shock threshold (350μsec-1msec), the number of weak shocks necessary to trigger an alarm (1-8), and the reset time of the weak shock counter.

Each configuration parameter and all maintenance data can be set and visualised using the exclusive WSyncTM wireless system, available for both smartphones and tablets. Read more

WSync allows wireless configuration and maintenance of VAS boards with the tip of your fingers, using either a tablet or a smartphone with Bluetooth and the free TSec App. By allowing the tuning of the configuration parameters directly where each vibration detector is installed, as opposed to where the analysis board is located, installation time and costs can be dramatically reduced, at the same time enhancing the quality and security of the system.

WSync is based on a proprietary accessory dongle that enables wireless operation of VAS boards. The dongle has been engineered so that it is used only during the initial or periodic configuration (maintenance) of the boards. In other words, it becomes one of the tools of the trade for security professionals.

WSync uses Bluetooth as a transmission means, and it has an indoor range of up to 15 meters.
Read more

Whether you are an avid smartphone user, or you prefer a PC for configuring and maintaining security devices, TSEC has got your back.
The free TSEC Apps, available both for Android and iOS systems, perfectly
complement the wireless configuration system WSync to dramatically
reduce installation and maintenance times. With modern, streamlined and responsive user interfaces, configuring a security device has never been so simple.
The suite is completed by software for PC, for environments where smartphones are not available.
Read more